Steris Amsco 3085 SP, Maintenance Manual

Page: 49 / 228

7-2
150830-353 Operator Manual Troubleshooting
No communication between
table control and hand
control.
Charge batteries per S
ECTION
6 .
Charge batteries per S
ECTION
6 .
NOTE: If batteries are totally discharged, control
shutdown will occur after 3-1/2 minutes when
table is in use or after 30 seconds if condition
exists at power up.
1. Check ac power cord – Replace power cord if
necessary.
2. Check F1 and F2 fuses – Replace fuse(s) if
necessary.
3. Reset circuit breaker CB-3.
4. Reset circuit breaker CB-4.
5. Reset circuit breaker CB-1.
1. Check hand control connection per S
ECTION
3 .
2. Replace hand control if necessary.
Turn hand control OFF, then ON to reset controls.
Replace foot control.
AC power connected; low or
discharged batteries (bat-
tery-powered table only).
Hand Control Diagnostics Chart
NOTE: When power supplies are operational and the table is plugged into an ac receptacle, the ON touch pad green LED
and ac power green LED will be ON.
1. Control ON – green AC
LED is ON and red BAT-
TERY LED is flashing.
INDICATION CONDITION CORRECTIVE ACTION
2. Control ON – green
BATTERY LED is ON and
red BATTERY LED flash-
ing.
Low or discharged batteries
(battery-powered table only).
3. Control ON – green
BATTERY LED (only) is ON
when table plugged into
AC receptacle.
Battery level acceptable;
faulty battery charger or
power circuit (battery-
powered table only).
4. All green, yellow, and red
LEDs flashing.
5. Green ON LED flashing. 1. Optional foot control switch
was actuated when hand
control switched ON;
control logic error disables
foot control functions.
2. Faulty foot control; foot
control function is dis-
abled.