Steris Amsco 3085 SP, Maintenance Manual

Page: 36 / 228

4-13
Operating Instructions Operator Manual 150830-353
4.6.4 Accessories
Specific to Amsco 3085
SP Tables
WARNING – PERSONAL
INJURY HAZARD: When in-
stalling any table accessory,
check for correct attachment
and tighten securely (if ap-
propriate). Do not use worn
or damaged accessory.
Check installation before us-
ing any accessory.
WARNING – INSTABILITY
HAZARD: Patient Transfer
Board must be used as a leg
support only. It is not intended
to support upper body weight
of a patient.
WARNING – TIPPING
HAZARD:
• Do not use two or more Uro-
Endo/Image Amplification
Extension Accessories to-
gether on the 3085 SP Table.
• Foot Extension Accessory or
combination of Foot Exten-
sion and Headrest Accesso-
ries from previous design
STERIS tables must not be
used for reverse orientation
on the 3085 SP Table.
• When performing surgery re-
quiring a headrest accessory
in reversed patient orienta-
tion, or when using a Fem/
Pop board or the 3080/3085
Ortho Extension accessory,
do not exceed the 400 lb (181
kg) patient weight.
• Do not use the Fem/Pop
Board with X-ray Tops for
bariatric patients.
the Amsco 3085 SP (see Figure 4-15) and Quantum 3080 tables. These
accessories are not intended to be used with any other previous-design STERIS
tables.
•
Uro-Endo/Image Amplification Extension – attaches to back section
ONLY. With headrest attached, it provides an additional 8" (203 mm) of I.A.
coverage. Without the headrest, for reversed patients, it also expands the
Uro-Endo procedure capability of table. Do not use more than one at a time.
(Limited to 400-lb [181 kg] patient load.)
•
Patient Transfer Board – inserts into Uro-Endo/I.A. Extension to support
patient's legs during transfer to table. It is intentionally flexible and is intended
to be removed after patient is positioned. (Limited to 400-lb [181-kg] patient
load.)
•
Drain Tray – slides onto perineal edge of seat section and Uro-Endo/I.A.
Extension. (Not limited to patient weight.)
•
Neuro Seat Plate – placed under pad by hooking support legs onto side
rail supports and allowing to rest on top of kidney bridge. It extends leg seat
length and provides for less than 90° seating (with kidney bridge elevated)
for unique reversed chair posture. (Limited to 400-lb [181 kg] patient load.)
•
Fem/Pop Board – intended to be installed into leg section only and used
as a leg support for improved lower body I.A. coverage. It is not intended to
support upper body weight. Do not use the Fem/Pop Board with X-ray tops
for obese patients. (Limited to 400-lb [181 kg] patient load.)
•
X-Ray Tops – removable cassettes can be inserted through the head, foot,
or side of table. (Acceptable for patient loads up to 1,000 lb [452 kg].)
•
3080/3085 Orthopedic Extension – attaches to seat section to
provide a mobile radiolucent orthopedic platform. (Limited to 400-lb [181 kg]
patient load.)
The following special accessories have been developed specifically for use with
the Amsco 3085 SP and Quantum 3080 tables. These accessories are not
intended to be used with any other previous-design STERIS tables.
•
Eye-ENT-Neuro Headrest Adapter – inserts into the frame headrest
bores to permit use of all previous design headrest accessories on the 3085
table. It maintains the same end-of-table relationship for accessories as when
used with previous design tables. (Limited to 300-lb [136 kg] patient load.)
•
Eye-ENT-Neuro Headrest Adapter with 4" Extension – inserts into
the frame headrest bores to extend back section an additional 4"
(101 mm). (Limited to 300-lb [136 kg] patient load.)
•
Foot Extension – clamps to side rails at either end of table to provide
additional patient support. (Limited to 500-lb [226 kg] patient load.)
•
Perineal Cutout Filler – attaches to tabletop to cover cutout and provide
additional patient support. (Limited to 400-lb [181 kg] patient load.)
For application of other STERIS table accessories to your Amsco 3085 SP table,
contact STERIS.