Steris Amsco 3085 SP, Maintenance Manual

Page: 51 / 228

8-1
Service Procedures Operator Manual 150830-353
CB-1
CB-2
CB-3
CB-4
8 SERVICE PROCEDURES
The material in this section is provided to allow for servicing components of the
Amsco
®
3085 SP Surgical Table most likely to need attention. These procedures
are more advanced than cleaning and replacing expendables. These proce-
dures should always be performed by an experienced, trained service techni-
cian.
Four circuit breakers (CB-1, CB-2, CB-3, and CB-4) protect various table
components* and may be reset if tripped by a fault condition. When tripped, the
circuit breaker will pop out and is readily detectable.
Reset circuit breakers as follows:
1. Lower foot pedal on table base to access circuit breakers (located on right
of opening when foot pedal is down). See Figure 8-1.
2. Press in on protective boot covering circuit breaker to reset.
3. Raise foot pedal back into stored position.
* CB-1 protects power transformer.
CB-2 protects motor batteries and has extra internal manual on/off switch.
CB-3 protects motor battery charger.
CB-4 protects control power supply.
8.1 Reset Circuit
Breakers
Circuit
Breakers
Foot Pedal
Figure 8-1. Circuit Breakers
WARNING – PERSONAL
INJURY AND/OR EQUIPMENT
DAMAGE HAZARD: Repairs
and adjustments to this equip-
ment must be made only by
fully qualified service person-
nel. Nonroutine maintenance
performed by inexperienced,
unqualified personnel or in-
stallation of unauthorized
parts could cause personal
injury, invalidate the war-
ranty, or result in costly dam-
age. Contact STERIS regard-
ing service options.