Steris Amsco 3085 SP, Maintenance Manual

Page: 33 / 228

4-10
150830-353 Operator Manual Operating Instructions
The headrest can be attached to either end of table (see Figure 4-1). Headrest
is manually adjustable 90° upward and 90° downward from horizontal position.
Adjust the headrest to desired position as follows:
1. See Figure 4-8. Locate release handle (under right side of headrest) and pull
to release (spring-loaded).
2. Tilt headrest upward or downward to desired position, let go of release
handle, then move headrest slightly until ratchet mechanism locks it into
position.
Kidney bridge elevation is manually adjustable up to a maximum height of 4"
(101 mm) above the primary tabletop. Adjust the kidney bridge for desired
elevation as follows:
1. Locate kidney bridge ratchet handle (under left side of back section) and flip
it down (spring-loaded). See Figure 4-9.
Lower
Raise
Figure 4-9. Kidney Bridge Adjustment
Kidney Bridge
Kidney Bridge
Ratchet Handle
Direction Selector
2. Set ratchet drive directional control (see Figure 4-10):
Figure 4-10. Set Ratchet Drive Directional Control
Partially Rotate
this Direction to
Engage "Lower"
Partially Rotate
this Direction to
Engage "Raise"
4.4 Headrest
Positioning
4.5 Kidney Bridge
Elevation
Headrest Adjustment
Release Handle
Figure 4-8. Headrest
Positioning
WARNING – INSTABILITY
HAZARD: Possible patient or
user injury, as well as table or
accessory failure, may result
from using STERIS table ac-
cessories for other than their
stated purpose - or from us-
ing, on STERIS tables, ac-
cessories manufactured and
sold by other companies.
WARNING – PERSONAL
INJURY HAZARD: When in-
stalling any table accessory,
check for correct attachment
and tighten securely (if ap-
propriate). Do not use worn
or damaged accessory.
Check installation before us-
ing any accessory.
CAUTION – POSSIBLE
EQUIPMENT DAMAGE: Use
caution when raising the seat
section or back section while
the kidney bridge is elevated.
The section may contact the
elevated kidney bridge and
damage the bridge and/or
section.
Partially Rotate
this Direction to
Engage "Raise"
Partially Rotate
this Direction to
Engage "Lower"
For Models Pre 2010
For Models After 2009