Steris Amsco 3085 SP, Maintenance Manual

Page: 27 / 228

4-4
150830-353 Operator Manual Operating Instructions
Adjust the tabletop position by using the hand control positioning buttons, as
follows (see Figure 4-3):
1. Press FLOOR LOCK Function button in center row of buttons on hand control
and within five seconds (while LED is still ON), press desired Actuate button
( LOCK or UNLOCK ) adjacent to it.
2. Press ORIENT PATIENT Function button in center row of buttons, and within
five seconds (while LED is still ON), press desired Actuate button ( NORMAL
or REVERSE ) adjacent to it to indicate patient orientation on table.
If no selection is made, table will default to NORMAL orientation.
3. Press desired positioning Actuate button.
4. When desired position has been reached, release positioning Actuate button
to automatically stop tabletop and lock it in position.
5. Range of nominal tabletop movements is as follows:
•
Trendelenburg ( TREND button) – 25° maximum from horizontal.
•
Reverse Trendelenburg ( REVERSE TREND button) – 25° maximum
from horizontal.
•
Height ( HEIGHT UP and HEIGHT DN buttons) – 27" (686 mm) minimum
to 44" (1118 mm) maximum.
•
Side Tilt ( TILT L and TILT R buttons) – 18° maximum to right or to left
of horizontal.
NOTE: Momentary delay may occur when activating Side Tilt while the safety
mechanism disengages the tilt-lock function.
•
Back ( BACK UP and BACK DN buttons) – up 55° maximum (80° in
REVERSE orientation) or down 25° maximum (105° in REVERSE orientation)
from horizontal.
•
Leg ( LEG UP and LEG DN buttons) – up 80° maximum (55° in REVERSE
orientation) or down 105° maximum (25° in REVERSE orientation) from seat
section.
NOTE: FLEX and REFLEX position controls are disabled when in REVERSE
patient orientation.
•
Flex ( FLEX button) – back section down 20° maximum with seat section
down 25° maximum from horizontal.
•
Reflex ( REFLEX button) – back section up 25° maximum with seat
section up 35° maximum from horizontal.
•
Return To Level – tabletop can be returned to level by pressing LEVEL
button. Table will move in gradual, anatomically correct increments until it
reaches level.
NOTE: If the LEVEL button is pressed while the green LED on the ORIENT
PATIENT Function button is still lit, the table will not return to level. Wait for
completion of the orient patient function (maximum five seconds) before
pressing the LEVEL button to activate the return-to-level function.
IMPORTANT: For table positioning when patient load exceeds average
weights, note the following:
1) When a normal patient load exceeds 700 lb (318 kg), Reflex and Return-
to-Level articulations may be slow or not operate. Use other articulations
to move the tabletops to the desired position.
WARNING – TIPPING
HAZARD: During an articula-
tion if the tabletop sections
contact an obstruction, the
table may tip. Before lower-
ing either the tabletop or indi-
vidual sections, remove pos-
sible obstructions. Do not al-
low leg section, when low-
ered, to contact the floor.
CAUTION – POSSIBLE
EQUIPMENT DAMAGE:
• During some extreme articu-
lations, the tabletop may con-
tact the base and/or column
shrouds. Take care to avoid
positioning the table in such
a way as to cause damage to
the shrouds.
• Use caution when raising the
seat section or back section
while the kidney bridge is
elevated. The section may
contact the elevated kidney
bridge and damage the bridge
and/or section.