PolosSpin150i/200i
rev.: 1.0
Operating instruction
SPS-Europe B.V.
page
32
JH131115
7.2 Preparations
Depending on used features and media, special preparations could be necessary:
refer to system specific datasheet for detailed information.
Make sure that mains supply, motor purge, CDA, vacuum and all required input are
connected.
Make sure that the drain system, if required, is properly connected and able to work
Inspect the system to assure that no damages or failures are present.
7.3 Powering on
Verify that all required supply is properly connected to connection panel
(2)
.
Turn the main switch
(1)
of the unit to <1>.
System screen interface will start showing several loading screen, wait until home
screen will been shown.
If any error indicator is active interrupt starting procedure and contact maintenance
service.
7.4 Open the lid
Following procedure described in software instruction, release the lid lock.
Gently lift lid’s latch and push the lid till hinge hold position, lid lock will be
reactivated after countdown expires however lid will hold this position forever.
For better access the chamber, the lid can be overturned until the end of hinge
travel.
CAUTION!
Always handle the lid latch gently otherwise plastic components could be damaged.
WARNING!
In case of power failure will not be possible to open the lid. Do not try to force it in
any way. Please refer to service documentation or ask system administrator for
further instructions.
2
1
