Version 5.2
Sourcefire 3D System Installation Guide
106
Setting Up a Sourcefire 3D System Appliance
Initial Setup Page: Defense Centers
Chapter 4
model-specific licenses allow your managed devices to perform a variety of
functions. Because of architecture and resource limitations, not all licenses can
be applied to all managed devices; see
Supported Capabilities by Appliance
on page 13 and
Licensing the Sourcefire 3D System
Sourcefire recommends that you use the initial setup page to add the licenses
your organization has purchased. If you do not add licenses now, any devices you
register during initial setup are added to the Defense Center as unlicensed; you
must license each of them individually after the initial setup process is over. Note
that if you are setting up a reimaged appliance and you kept your license settings
as part of the restore process, this section may be pre-populated.
If you have not already obtained your licenses, click the link to navigate to
https://keyserver.sourcefire.com/
and follow the on-screen instructions.
You need your license key (listed on the initial setup page), as well as the
activation key previously emailed to the contact associated with your support
contract.
