Version 5.2
Sourcefire 3D System User Guide
254
Using SFP Transceivers on a 3D7115 or 3D7125
Removing an SFP Transceiver
Appendix B
3.
Follow the procedure in
Installing a Sourcefire 3D System Appliance
page 57 to configure the port on the transceiver.
Note that if you insert a transceiver into a device currently in operation, you
must refresh the user interface on the Defense Center to view the change.
Removing an SFP Transceiver
Use appropriate electrostatic discharge (ESD) procedures when removing the
transceiver. Avoid touching the contacts at the rear, and keep the contacts and
ports free of dust and dirt.
To remove an SFP transceiver:
1.
Disconnect all cables from the transceiver you want to remove from the
device.
2.
Using your fingers, gently pull the bale of the transceiver away from the
chassis to disengage the connecting mechanism.
For transceivers in the upper row, pull down. For transceivers in the lower
row, lift up.
3.
Using your fingers, grasp the sides of the bale and use the bale as a handle to
gently pull the transceiver out of the chassis, taking care not to touch the
contacts at the back of the transceiver.
