Sony DVS-7250, Operation Software

Page: 311 / 542

Chapter 8 Key Frame Effects
8-23
Path settings within an M/E bank or the PGM/PST bank
Making path settings for individual items within an M/E bank or
the PGM/PST bank
For example, in the case of the M/E-1 bank, use the following procedure.
For the M/E-2 and PGM/PST bank, use a corresponding procedure.
1
In the SWER KF PATH menu, press F2 (M/E-1).
The function key indications change as follows.
(F6 (CHR KEY) does not appear for the PGM/PST bank.)
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
CURVE
CHR
KEY
LINEAR LINEAR
TRANS
LINEAR LINEAR LINEAR
KEY1
LINEAR OFF
KEY2 WIPE
COLOR
BKGD
XPT
DSBL
HUE
PATH
2
Press one of F1 (KEY1) to F6 (CHR KEY) to select the corresponding
curve path type.
Pressing each of F1 to F6 cycles through the settings in the order shown
below. F1 (KEY1), F2 (KEY2), F4 (TRANS), and F6 (CHR KEY) cycle
through four settings excluding “SPLINE”.
OFF t STEP t LINEAR t S-CURVE t SPLINE
The selected path type is shown on the menu display by an icon.
3
If you selected “SPLINE” in step 2 , adjust control knobs 1 to 3 as
follows.
4
Press F10 (HUE PATH), then select the HUE path type.
For details, see steps
4
and
5
in the section “Setting the path for all
banks” (page 8-21).
Knob Parameter Setting
1 Tension Degree of tension between points (–4.000 to +4.000)
2 Bias Degree of inclination of tangent at point (–4.000 to +4.000)
3 Continuity Degree of continuity at point (–4.000 to +4.000)