Sony BVP-550, Maintenance Manual

Page: 898 / 924

4-44(E)
BVP-550
BVP-550P
4-4. Overall Electrical Alignment
5. Set the menu as follows.
MENU : Paint
PAGE : Knee/W.Clip (P6)
ITEM : Test
→
Off
6. Set the GAIN switch (on the side panel)
→
L (0 dB).
Note:
The values used in the above adjustments are under the
conditions when the white clip level is set to 109 IRE (for
NTSC) or 763 mV (for PAL).
When the white clip level is set to other value than 109
IRE or 763 mV, use the following table to set the levels of
the knee point and knee slope.
White Clip Level (Unit: IRE/mV)
109/763 107/749 105/735 103/721
Knee point 98/686 98/686 96/672 96/672
Knee slope 109/763 107/750 107/750 107/750
White clip 109/763 107/749 105/735 103/721
• As for the detail adjustments, refer to Sections 4-2-9 to
4-2-17. Adjust according to the customer’s preferences.
4-4-20. VTR R-Y/B-Y Adjustment
Equipment : Oscilloscope
Test points : TP4,TP5/DA-88
Preparations:
OUTPUT/DCC switch (on the side panel)
→
BARS
Adjustment procedures:
1. Connect the oscilloscope to the TP4 (E4) (GND:E1
(F4))/DA-88 Board.
2. VTR R-Y Adjustment
Adjustment point :
MENU : System config
PAGE : VTR/CCU (S5)
ITEM : VTR R-Y
Specifications
: A = 700
±
5 mV (for NTSC)
: A = 525
±
5 mV (for PAL)
3. Connect the oscilloscope to the TP5 (F4) (GND:E1
(F4))/DA-88 Board.
4. VTR B-Y Adjustment
MENU : System config
PAGE : VTR/CCU (S5)
ITEM : VTR B-Y
Specifications
: B = 700
±
5 mV (for NTSC)
: B = 525
±
5 mV (for PAL)
5. MENU Setting :
MENU : Triming File
PAGE : Triming File (T1)
ITEM : File Store
Press the MENU SEL switch (on the front panel) to
execute the triming file store.