Sony BVP-550, Maintenance Manual

Page: 306 / 924

4-32 (E)
BVP-550
6. Set the R/G/B switch (on the side panelüj to ENC.
7. Set the OUTPUT/DCC switch (on the side panel) to
CAM/OFF.
8. Set the menu as follows, and adjust the A/D gain for R
by using the MENU SEL switch.
MENU : System config
PAGE : PR/VA/TEST (S3)
ITEM : PR AD G [R]
Specifications : Minimize the carrier leakage.
C = Minimum
9. Set the menu as follows, and adjust the A/D gain for B
by using the MENU SEL switch.
MENU : System config
PAGE : PR/VA/TEST (S3)
ITEM : PR AD G [B]
Specifications
: Minimize the carrier leakage.
C = Minimum
10. Repeat the steps 8 and 9 alternately until the specifica-
tions are satisfied.
File Store:
Execute the file store. Press the MENU SEL switch to
execute.
MENU : Triming File
PAGE : Triming File (T1)
ITEM : File Store
Resetting after Adjustment:
• Set the menu as follows.
MENU : System config
PAGE : PR/VA/TEST (S3)
ITEM : TEST
→
Off
4-3-10. VA Gain Adjustment
Setting of Sensitivity and Standard Color Temperature:
• Use the reflective chart (reflection ratio:89.9%)in this
adjustment, if possible.
• If a pattern box is used, it should be well-maintained.
• Set the luminous intensity of the chart to 2000 lx and the
color temperature to 3200 K.
• This adjustment shall be performed at F7.0 or more.
Note:
• Never change the setting of the following trimmer
capacitors. These capacitors are extremely difficult to
adjust in the field.
VA-163 board :
1
CT200,
1
CT300,
1
CT400
Equipment
: Oscilloscope, Waveform monitor
Object : Grayscale chart
Preparations:
• WHITE BAL switch (on the side panel)
→
PRST
• GAIN switch (on the side panel)
→
L (0 dB)
• Extend VA-163 board with EX-464 board.
• RGB/ENC switch (on the side panel)
→
ENC
Adjustment Procedures:
1. Set the DISP switch (on the side panel) to MENU
while holding down the MENU SEL switch (on the
front panel).
2. Set the menu as follows.
MENU : Paint
PAGE : Knee/W.Clip (P6)
ITEM : Knee
→
Off
3. Close the lens iris.
4. Execute the level auto setup.
Press the MENU SEL switch to execute.
MENU : Operation
PAGE : Auto Setup
ITEM : Level Auto
5. Confirm the black level is 3 IRE for NTSC and 21 mV
for PAL at the TEST OUT connector.
If the black level is out of specs, carry out “4-3-14.
Master Black Adjustment”.
4-3. Overall Electrical Alignment
4-3-9. A/D Gain Adjustment
4-3-10. VA Gain Adjustment