LC2000/LC2000-IQ/LC4000/LC4000-IQ
Channel Operation Menus
Issue 1 Rev 6
Page 80
© 2015 SAM
•
Dolby Encoder (if fitted)
For schematic information on audio routing, see “Block Diagrams” on page 15.
To route the AES and analog audio outputs, see “Audio Routing” on page 38.
For more information about audio routing, see the
Audio Processing Application Note
under
the “Support” tab at:
www.snellgroup.com/products/conversion-and-restoration/conversion/kudospro/
8.7.1.3
Process Pairs 1–8 Status
The Status list shows the status of the audio output pairs.
The audio status display information is as follows:
•
P = PCM
•
L = Loss
•
N = Non-PCM
8.7.2 Control
The Control menu enables you to adjust the gain of the audio channels
8.7.2.1
Gain
•
Pair 1–8 L/R:
Adjust the gain of the left and right channels of the audio pairs. The
adjustment range is -12 dB to 12 dB in 0.1 dB steps. The preset value is 0 dB.
8.7.2.2
Tone Frequency
The Tone Frequency slider adjusts the frequency of the test tones. The adjustment range is
0.1 KHz to 10 KHz in 0.1 KHz steps. The preset value is 0
Note:
AES and analog audio are controlled at a frame level, not at a channel level.
