LC2000/LC2000-IQ/LC4000/LC4000-IQ
RollCall Control Panel Channel Operation Screens
Issue 1 Rev 6
Page 142
© 2015 SAM
•
Dolby Decoder 1–4 (if fitted):
You can select each of the four audio pairs from the
Dolby decoder individually:
•
Dolby decoder 1 is pair 1 from the Dolby decoder
•
Dolby decoder 2 is pair 2 from the Dolby decoder
•
Dolby decoder 3 is pair 3 from the Dolby decoder
•
Dolby decoder 4 is pair 4 from the Dolby decoder
•
Dolby Decoder Downmix (if fitted):
The Lt/Rt downmix (applicable to 5.1 and 4
channel Dolby formats).
•
Dolby Encoder (if fitted):
Routes the dolby encoder audio pair.
For schematic information on audio routing, see “Block Diagrams” on page 15.
To route the AES and analog audio outputs, see “Audio Routing” on page 98.
11.6.1.2
Status
The Status box shows the status of the audio input pairs. The audio status display information
is as follows:
•
PCM: Audio is PCM
•
Mute: Audio is muted
•
Tone: Audio is a test tone
•
DolbyE: Audio is Dolby
•
Loss: Audio is unavailable or invalid
11.6.2 Process Pairs
For each of the output pairs, 1–8, you can select the audio source from various inputs.
11.6.2.1
Status
The Status box shows the status of the audio output pairs. The audio status display
information is as follows:
•
P = PCM
•
L = Loss
•
N = Non-PCM
11.6.2.2
Pair 1–8
For each of the output pairs, 1–8, you can select the audio source to be passed to each audio
processor on the Audio Shuffle screen.
For more information about audio routing, see the
Audio Processing Application Note
under
the “Support” tab at:
www.snellgroup.com/products/conversion-and-restoration/conversion/kudospro/
Note:
AES and analog audio are controlled at a frame level, not at a channel level.
