Smartgen HGM 9310CAN Series, User Manual

Page: 47 / 77

HGM93XX MPU(CAN) SERIES GENSET CONTROLLER
HGM93XX MPU(CAN) Series Genset Controller Version: 1.1 2016-11-03 Page 47 of 77
29 Close Generator Control generator to take load.
30 Open Breaker Control generator to off load.
31 Close Mains Control mains to take load.
32 Reserved
33 Start Relay
34 Fuel Relay
Action when genset is cranking and disconnect when
stopped completely.
35 Idle Control
Used for engine which has idles. Close before starting
and open in warming up delay; Close during stopping
idle mode and open when stop is completed.
36 Raise Speed Action in warming up delay.
37 Drop Speed
Action between the period from “stop idle” to “failed to
stop”.
38 ETS Control
Used for engines with ETS electromagnet. Close when
stop idle is over and open when pre-set “ETS delay” is
over.
39 Pulse Drop speed
Active 0.1s when controller enters into stop idle, used
for control part of ECU dropping to idle speed.
40 ECU Stop Used for ECU engine and control its stop.
41 ECU Power Used for ECU engine and control its power.
42 Pulse Raise Speed
Active 0.1s when controller enters into warming up
delay; used for control part of ECU raising to normal
speed.
43 Crank Success Close when detects a successful start signal.
44 Generator OK Action when generator is normal.
45 Generator Available
Action in period of generator is normal running to
hi-speed cooling.
46 Mains OK Action when mains is normal.
47 Reserved
48 Common Alarm
Action when genset common warning, common
shutdown, common trips alarm.
49 Common Trip and Stop Action when common trip and stop alarm.
50 Common Shutdown Action when common shutdown alarm.
51 Common Trip Alarm Action when common trips alarm.
52 Common Warning Alarm Action in common warning alarm.
53 Reserved
54 Battery High Volts Action when battery’s over voltage warning alarm.
55 Battery Low Volts Action when battery’s low voltage warning alarm.
56 Charge Alt Fail Action when charge failure warning alarms.
57 Reserved
58 Reserved
59 Reserved
60 ECU Warn Indicate ECU sends a warning signal.
61 ECU Shutdown Indicate ECU sends a shutdown signal.
62 ECU Com Fail Indicate controller not communicates with ECU.