SKF Baker AWA-IV 12 HO, User Manual

Page: 147 / 214

Conducting Surge tests with the Baker PP30 three-phase test lead power
pack
1) After setting up the power pack and analyzer, on the Baker AWA-IV, select the motor
to be tested from the Explore tab.
2) Click on the Tests tab to get to the main testing screen.
3) Select a Test ID that uses a voltage requiring the power pack, or create a test that
does.
4) Click on the test configuration button at the end of the Surge test row. The Surge
Test setup window will appear.
5) Adjust the voltage required so that surge voltage is at least 5000 volts.
6) Enable the power pack by checking the
Enable PP box. An error message will
appear if a voltage below the minimum for the power pack is programmed after the
Enable PP box is checked.
7) Click on the Pause between Leads button in the Surge Test setup window.
Figure 128. Setting up Surge test for power pack.
8) Turn the power packs’s Voltage Output Control know on the power pack to MIN (full
counterclockwise).
9) Select the Surge test using the Function knob on the power pack.
PUB CM/I4 71-015 EN V13.2 Static Motor Analyzer—Baker AWA-IV User Manual 127
Using power packs with 6/12 kV models