SKF Baker AWA-IV 12 HO, User Manual, Page: 75 / 214

Using the Tests tab
Clicking on the Tests tab changes the display area in the right side of the Main window as
shown in the example below. This is the main testing window. Each test the analyzer
performs is indicated by several columns of buttons that show the test status.
In the left-most column are
On/Off
buttons that show if a test is active. Click on the related
button to turn each test on or off.
Click the buttons in the center column to execute the particular test. This is considered semi-
automatic testing.
Figure 56. Test view.
Use the test configuration buttons to open a new window used to configure each test. The
button labels indicate how each test is set up, how many leads will be used, the test voltage
applied, and so on. Each test’s configuration window is described below.
A fourth shaded column appears at the end of testing. Green indicates that the test passed;
red that it failed. A red indicator also displays the reason the test failed.
To run an automatic test, click the
Run Auto Test
button. Each test that is turned on will be
performed in the sequence as it appears in the
Tests
tab view.
To edit Test IDs, click on the Edit Test ID check box. You will be prompted for a password. If
this is the first time you are editing a Test ID since the Baker AWA-IV software’s installation,
click on the Change Password button and enter the password in its field.
Click on the Set Password button.
If this is not the first time you are editing a Test ID, simply enter the password and click OK.
Three new buttons will appear below the Test ID. Use the Save button to save changes you
make to the selected Test ID. Use the Add button to add a new blank Test ID or to copy a
selected Test ID. Use the Delete button to delete the selected Test ID. When you are finished
editing Test IDs, or if you decide not to edit, uncheck the Edit Test ID box to disable Test ID
editing.
NOTE
Leaving the Tests view will also disable the editing of Test IDs and all changes will
be lost if they have not been saved.
PUB CM/I4 71-015 EN V13.2 Static Motor Analyzer—Baker AWA-IV User Manual 55
Baker AWA-IV software overview