Simrad WBT Mini, Instruction Manual

Page: 22 / 68

20
425197/B
Procedure
1 Open the
Setup
menu.
2 On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens. This dialog box contains a number of
pages that you select from the menu on the left side.
3 On the left side of the
Installation
dialog box, select
Transceiver
.
4 Install the channels(s).
a Observe that the transceiver(s) you have connected to the PC are listed.
Each transceiver is identified with type and serial number. The available channels
on each transceiver are listed separately.
b For each channel, choose which transducer to connect to.
The list of transducers available for installation is defined by those you installed
on the
Transducer
page.
Note
This is a critical task. Make sure that the correct transducer is selected.
c Observe that the status for the relevant frequency channels change to Installed .
Tip
If no transceivers are listed:
• Select
Browse
in the
Transceiver Browsing
box, and open the
Local IP Address
box.
Select the correct address for the Ethernet adapter you are using. This will make the
EK80 program search the network for available transceivers.
• Check that each transceiver has been turned on.
• Verify that the Ethernet communication between the units is operational.
• If you are using an Ethernet switch, make sure that it works.
5 At the bottom of the page, select
Apply
to save your settings.
6 Repeat until all the channels have been installed.
7 Continue your work in the
Installation
dialog box, or select
OK
to close it.
Simrad WBT Mini Instruction Manual