Silca UC 199, Operating Manual

Page: 36 / 107

Lower the safety shield and press START to continue.
NOTE: in ‘exceptional’ cases (e.g. machine breakdown) the key can be removed from the automatic
clamp ‘manually’:
5) raise the safety shield.
6) use a 5 mm hex wrench on the automatic clamp screw (D5) in order to open the jaws.
7) remove the key (blank or cut) and close the jaws with the 5 mm hex wrench.
8) remove the 5 mm hex wrench and lower the safety shield.
Fig. 42
NOTE: if the absence of key blanks in the loader is detected during the cycle, the display will show:
FEEDER EMPTY
Pieces maked: x / y
Continue?
No=STOP Yes=ENTER
Open the guard and insert one or more key BLANKS (according to needs). At the cutting stage it can be used to
know how many keys should be added to finish the job.
NOTE: press SHIFT + START to continue, even if the key has not been detected (e.g. head bore too
big).
Operating Manual
UC199
Copyright Silca 2012
32