Silca UC 199, Operating Manual

Page: 30 / 107

4.8 CHANGING CUTTING TOOL
1) Zero the carriage movements (from the main menu press SHIFT+STOP).
2) Turn off the power to the key-cutting machine.
3) Raise the safety shield.
4) Loosen the screw (D2) (Fig. 38), pull out the clamp to the left and remove (see Ch. 4.7 for the automatic
clamp).
5)
Fit the cutter release rod (X) provided into the special hole (if a new cutter is being fitted to replace a worn
one, or in order to sharpen the cutting edge (Fig. 37).
6) Use the 14 mm wrench (X1) to loosen the cutter locking nut.
ATTENTION: the thread is left-handed.
7) Replace the cutter, tighten the nut and remove the rod from the hole.
8) Fit the clamp unit and push all the way in to the right. Tighten the screw (D2).
Fig. 37
ATTENTION:
if a new cutter is being fitted to replace a worn one, or in order to sharpen the
cutting edge, see Ch. 5.7 [4] Calibrations.
Fig. 38
open
close
Operating Manual
UC199
Copyright Silca 2012
26