Silca UC 199, Operating Manual

Page: 43 / 107

•
IF THE OPTIONAL FEEDER IS INSTALLED:
1- [316]
Pieces: 1 of: 3
Manual cycle = START
Press START to start the MANUAL CYCLE
1+ [316]
Pieces: 1 of: 1
MAN. CYC. IN PROGRESS
Press CLEAR to
stop the cycle
MANUAL CYCLE
The manual cycle is enabled by default: if there are a number of jobs in the PC queue, start the first one; when
the job is finished the machine will stop to wait for new orders.
Press SHIFT+START to start the AUTOMATIC CYCLE.
AUTOMATIC CYCLE
The automatic cycle can be enabled: if there are a number of jobs in the PC queue, start the first one; when the
job is finished the machine does not wait for new orders but starts the second job immediately.
ATTENTION:
if there are keys set up in the feeder for several jobs (if the profile is not the
same) these must be checked before starting work.
When CLEAR is pressed (for about 2 seconds) the cycle stops. The cut being made will be
completed and then the carriages will stop in their initial position.
Stopping cycle
in progress …
Feeder ready
Adaptor:
Pcs.:2/3 [START]
Operating Manual
UC199
Copyright Silca 2012
39