Silca UC 199, Operating Manual

Page: 34 / 107

during the reading stage the key blank is also cut.
Copy: 1 of: 1
finished.
More copies ?
No=STOP Yes=ENTER
Press ENTER to repeat the cycle and copy more keys.
If a number of pieces over 1 (e.g. 3) has been set, the following sequence will occur:
Reading & cutting
in progress
Install the
Key blank on left
Adaptor:
Pcs: 2 / 3 [START]
Press STOP to return to the main menu.
5.3 [1] COPY FROM AN ORIGINAL
- CONFIGURATION WITH OPTIONAL LOADER UNIT
NOTE: check the parameters of the key to be cut with those given in Fig. 27 page to verify whether
to use Side A or B of the standard clamp, and whether the automatic clamp should have jaws “A”,
“B” or “A/2,0÷2,8”.
Operational keys: use the arrow keys [Up/Down] to move the cursor to the option required and press ENTER.
1- Copy from original
2- Copy with adjust.
3- Queue from PC
4- Calibrations >>
5- Maintenance
6- Options
1) With the pointer on position 1, press ENTER to select the function.
Original on right
Feeder ready
Adaptor:
Pcs: 1 / 10 [START]
2)
place the original key into the R/h clamp. Lower the gauge
.
3) the key blank (or blanks) into the loader, with their backs towards the operator.
4) press the arrow keys [< >] keys to set the number of keys to be cut.
Press START to see on the display at first:
Operating Manual
UC199
Copyright Silca 2012
30