Silca UC 199, Operating Manual

Page: 70 / 107

ATTENTION
Install clamp:
L100
[ENTER]
•
A Machine Zeroes operation that requires the standard cutting clamp (L100=Standard clamp) is about to take
place but the clamp is not detected.
ATTENTION
Clamp
L100
not calibrated !
ATTENTION
Clamp
L1
not calibrated !
•
The gauging values are missing. Proceed with Gauging menu (see Ch. 5.7).
FEEDER EMPTY
Pieces maked: x/y
Continue?
No=STOP Yes=ENTER
•
A gauging or CUTTING operation with Loader Unit is about to take place. No key blanks are detected in the
loader. Lift the safety shield and insert one or more KEY BLANKS (according to needs).
NOTE: press SHIFT + START to continue, even if the key has not been read (e.g. head punch too big).
Press SHIFT + START to exclude the sensor control. The exclusion is valid until the machine is turned off for the
first time.
ATTENTION
Before proceeding
read carefully the
operating manual.
•
Consult the manual (for the operation required) and press ENTER to continue.
ATTENTION
Remove key from
clamp!
[START]
•
Press START, raise the safety shield and remove the key from the clamp. This done, press START to continue.
Zero the axes!
[START]
•
Operation required on start-up or when a procedure has been interrupted. Press START to continue.
ATTENTION
X/Y gauged beyond
the advisable
tolerance range!
•
Gauging values exceeded max. tolerance allowed (+/- 30 hundredths of a mm). Repeat the gauging procedure.
Operating Manual
UC199
Copyright Silca 2012
66