Siemens SIMATIC TIM 3V-IE DNP3, System Manual

Page: 166 / 354

The SINAUT Configuration Tool
6.6 TD7onTIM
TIM DNP3
166
System Manual, 12/2015, C79000-G8976-C253-04
Mirroring back: You will find an description of the function in the section in the section
Mirroring back (Page 183).
The DNP3 implementation level is specified for every subscriber in the SINAUT configuration
tool:
> Subscriber Administration > TIMs with TD7onTIM > All Destination Subscribers
You will find a table sorted according to TD7onTIM objects in the section Objects of
TD7onTIM (Page 177).
TD7onTIM objects not supported
The "Par12x1D_R" object is not supported for the DNP3 protocol.
6.6.3 Configuring TD7onTIM (overview)
Configuring the TD7 software
The configuration of TD7onTIM is set in the subscriber administration of the SINAUT
configuration tool in the following steps:
1.
Parameter assignment / configuration of the basic settings for each TIM with TD7onTIM
2. Specifying the parameters specific to the destination subscribers
3. Adding objects:
The objects are grouped together in the TD7onTIM library that is called from the
subscriber administration.
–
System objects
Using the system objects, system information is displayed and communications
functions are activated and set.
– Data objects
Which data is to be sent or received is configured using standardized data objects.
– MODBUS-specific objects
MODBUS-specific properties are configured with these objects.
4. Parameter assignment / configuration of the objects
5. Parameter assignment / configuration of the send and receive channels of the data
objects
Basic settings for TIMs with TD7onTIM
For each TIM with TD7onTIM, several settings must be made that are always required for
communication, for example specifying the read/write cycle.