Operating Instructions
Chapter
10
CLX490
8009237/RB47/2007-08-03
©
SICK AG · Division Auto Ident · Germany · All rights reserved
10-17
Appendix
directory, you must specify a
new directory
.
Both versions of the software are then available
but must not be started simultaneously.
The configuration files "*.scl " (scanner configuration), "*.npj" (network project), "*.opj" (OTS
project) or "*.rpj" (redundant OTS project) of the old version can be used in the new version
and contain the CLX parameter sets as well as project data if serveal scanners had been
organized logically by projects. In order to do so, copy the configuration files from the "data"
directory of the old version to the "data" directory of the new version.
Installing the new version over the old one
Before you can install the new version of the software, you must remove the files of the old
version – with the exception of the configuration files "*.scl " (scanner configuration), "*.npj"
(network project), "*.opj" (OTS project) or "*.rpj" (redundant OTS project). They contain the
CLX parameter sets as well as project data if serveal scanners had been organized logically
by projects.
The deinstaller of the old version removes the program files. You can use the deinstaller to
remove all of the files (with the exception of the configuration files) or only selected files. The
default setting is a complete deinstallation (the configuration files are not deleted). With the
custom deinstallation, the files are listed and only selected files are deinstalled. If you
choose this deinstallation method, make sure that the main directory containing the config-
uration files "*.scl" is not deleted. We recommend that you move these files to a different
directory and copy them back to the "data" directory later.
1.
From the Windows Start menu, choose P
ROGRAMS
and the deinstaller for CLV-Setup. The
deinstaller starts and guides you step by step through the deinstallation procedure.
2.
Choose the deinstallation method (complete or custom).
3.
Install the new version of CLV-Setup as described under
Initial installation,
making sure
to choose the same directory.
The new version of CLV-Setup is installed. The configuration files of the old version can be
used again.
