CHAPTER 1. OUTLINE OF THE PRODUCT
PN-T321/T322B
OUTLINE OF THE PRODUCT
1 – 8
■
INSTALLING THE BATTERIES
Batteries and an insulation sheet are preinstalled in the remote control
at the factory. Before using the remote control, be sure to remove the
insulation sheet.
■
CHANGING THE BATTERY
1 ) Pull out the battery case.
Press the catch on the battery case while pulling out the case.
2 ) Insert the battery.
Make sure the polarities (+ and -) of the battery are oriented cor-
rectly.
3 ) Insert the battery case into the remote control.
Insert until you hear a click.
MEMO
n
Do not use a battery other than a CR2025 battery.
n
The preinstalled batteries in the remote control were installed at
the factory, and therefore may become depleted before the spec-
ified usage time is reached.
n
When the batteries become exhausted, replace them with new
(commercially available) batteries.
n
If you will not be using the remote control for a long time, remove
the batteries.
■
REMOTE CONTROL OPERATION RANGE
The operation range of the remote control unit is approx. 16.4 feet (5 m)
at an angle of approx 10° from the center to the top/bottom/right/left of
the remote control sensor.
CAUTION
n
Do not expose the remote control unit to shock by dropping or
stepping on it. This could lead to a malfunction.
n
Do not sit with the remote control in your pants pocket. This may
break the remote control.
n
Do not expose the remote control unit to liquids, and do not place
it in an area with high humidity.
n
The remote control unit may not work properly if the remote con-
trol sensor is under direct sunlight or strong lighting.
n
Objects between the remote control unit and the remote control
sensor may prevent proper operation.
n
Replace the batteries when they run low as this may shorten the
remote control’s operation range.
n
If a fluorescent light is illuminated near the remote control unit, it
may interfere with proper operation.
n
Do not use it with the remote control of other equipment such as
air conditioner, stereo components, etc.
7
INPUT
button
The menu is displayed. Press
or
to
select the input mode, and press
to enter.
You can select the input terminal by pressing
the input switch of the monitor.
*
1
If audio will be not input by HDMI cable,
use the PC audio input terminal.
*
2
Image and audio files in the USB flash
drive can be displayed/played.
8
MENU
button
Displays and turns off the menu screen.
9
SIZE button
The menu is displayed.
Press
or
to select the screen size.
n
When the input mode is “USB”, the screen
size cannot be changed.
n
The menu disappears after about 4 seconds
if you do not press any buttons.
Input mode
Video
Audio
*
1
*
2
DVI-D
PC/AV DVI-D
input terminal
PC audio
input
terminal
USB
USB port
---
D-SUB
PC D-SUB input
terminal
HDMI
PC/AV HDMI
input terminal
COMPONENT AV COMPONENT
input terminal
VIDEO
AV video input
terminal
AV audio
input
terminal
Insulation sheet
Pull out
Battery case
Catch
Lithium battery
(CR2025)
Remote control sensor
16.4 feet
(5 m)
10
10
10
10
