SEW-Eurodrive MOVIGEAR DAC B, Operating Instructions Manual

Page: 199 / 258

Operating Instructions – MOVIGEAR® DAC-B
199
12
Inspection and maintenance intervals
Inspection and Maintenance
12.2 Inspection and maintenance intervals
The following table shows shows the inspection and replacement intervals for
MOVIGEAR
®
:
Time interval Required steps Who is permitted to
perform the work?
Every 3000 operating hours, at least
every 6 months Check running noise for possible
bearing damage Qualified staff at the
customer
In the event of a bearing damage:
Have bearing replaced by SEW-
EURODRIVE Service SEW-EURODRIVE
Service
Visually check the seals for leakage Qualified staff at the
customer
In the event of a leakage at the output
oil seal: Replace the oil seal Qualified staff at the
customer
In the event of any other leakage:
Consult SEW-EURODRIVE SERVICE SEW-EURODRIVE
Service
For gear units with a torque arm:
Check rubber buffers and replace them
if necessary Qualified staff at the
customer
Recommendation:
Every 10 000 operating hours
1)
1) The amount of wear depends on many factors and may be high. The system manufacturer must calculate
the required inspection/maintenance intervals individually in accordance with the project planning
documents.
Motor inspection by SEW-
EURODRIVE Service SEW-EURODRIVE
Service
MOVIGEAR
®
is supplied with long-
term lubrication. Depending on the
operating conditions and the oil
temperature, the oil must be changed
at least every 5 years (see chapter
"Lubricant change intervals")
Change synthetic oil Qualified staff at the
customer
Replace output oil seal (do not install it
in the same track) Qualified staff at the
customer
Varying (depending on external
factors) Touch up or renew the surfaces/
anticorrosion coating Qualified staff at the
customer