Sens SG-A1, User Manual

Page: 23 / 100

SENS.413347.015RE
23
N
o.
Item Subitem (parameter) Note
Designati
on
Name
Desig
nation
Name, unit of measurement
С09
Calibration of output current
20 mA of 4...20 mA interface
С10
Save value of current during
calibration of interface 4...20
mA
Cont. of table 8.3
No
.
Item Subitem (parameter)
Note
Designati
on
Name
Desig
nation
Name, unit of measurement
5 CAL. Calibration
C11 Initialization of factory
calibration settings for
primary transducer Set in accordance with
8.5.3.6.
С200
Exit emulation mode Set in accordance with
8.4.2.16.
С201
Enter emulation mode
С210
Exit verification mode
Performed in accordance
with 8.5.3.5, 8.5.4.
C211 Enter verification mode Performed in accordance
with 8.5.3.5, 8.5.4
C222 Factory reset Performed in accordance
with 8.4.2.17
С230
Exit administrator
mode Performed in accordance
with 8.4.2.6.
After changing gas
detector settings in
operation mode with
administrator access level,
to save changes , it is
necessary to run command
C230 .
С231
Enter administrator
mode
6 PSd. Access control P1 Password to enter mode for
changing parameters
(administrator mode) Set in accordance with
8.4.2.6.
7 SADA Configuration of
RS-485 port
parameters rS Data rate Set in accordance with
8.4.2.14.
rP Parity
SP Protocol switch