Installation manual
PSC1-C-10 Installation manual V2.6
Page 126 of 173
Version: 57E
7
Commissioning
7.1
Procedure
Commissioning is only allowed to be undertaken by qualified personnel!
Please follow the safety instructions during commissioning!
7.2
Sequences for switching on
Each time after restarting the module, if there are no errors, the following phases are run through and
displayed on the seven-segment display on the front:
7-segment
display
Mode
Description
"1"
STARTUP
Synchronisation between both processor systems and checking
the configuration/firmware data
"2"
SENDCONFIG
Distribution of the configuration/firmware data
and further checking of these data. Subsequent
range calculation for the configuration data.
"3"
STARTUP BUS
If present, initialisation of a bus system
"4"
RUN
Normal operation of the system. All outputs are switched
based on the actual state of the logic.
"5"
STOP
Parameter data and program data can be loaded externally in
the stop mode.
"A"
ALARM
Alarm can be reset via digital input or reset button on the
front.
"E"
ECS alarm
ICS alarm
ACS alarm
ECS alarm can be reset via digital inputs or reset button on the
front.
"F"
Fault
Faults can only be reset via module ON/OFF.
"."
F-Bus Status
Off:
F bus not used
Slow flashing
F bus configured, no connection to the
master
Fast flashing
Connection to the master, F bus activation
pending
On
F bus connected
