schmersal bp408, Installation Manual

Page: 109 / 122

Installation manual of system “bp408” - Commissioning 109
The detachable bumpers are installed and functional. Yes □
The required switching magnets in the shaft are installed according to the impulse diagram. Yes □
The correction switches are installed, configured and tested for functioning according to
the deceleration distance.
Yes □
The setting drive with the absolute encoder AWG-05 is carried out as described. (chapter
8.12.3)
Yes □
The setting drive with the drive is carried out as described by the manufacturer. Yes □
If there is a DCP connection to the inverter, the setting drive with the DCP parameters is
carried out as described. (chapter 8.6.4)
Yes □
The brake application points are set such that a proper deceleration is possible until
standstill.
Yes □
The car door blade passes through the outer door rollers at a sufficient clearance. Yes □
If you have answered all questions with »Yes«, then you can proceed as follows.
Keep the doors closed, see maintenance menu. Switch off the landing control. Yes □
Before the first start, place the car levelled in the upper or lower stop with the inspection or
return control.
Yes □
After switching back to normal operation (inspection and return control off), the LC display
shows the status for the lower or upper stop.
Yes □
Now start the lift from the machine room, with the »Up« or »Down« buttons to control the
free travel through the shaft.
Yes □
In the menu
DIAGNOSIS > SHAFT SIGNALS
, you can control the incoming impulses for
the shaft copying.
Yes □
In the menu
DIAGNOSIS > SIGNALS
, you can control the input and output signals. Yes □
After the first drive, you can control the levelling position, the brake application points and,
in the case of regulated lift systems, the control parameters and optimise them as required.
Yes □
Now check the course of the drive via the car control panel at all upward and downward
stops.
Yes □
Switch on the landing control and now monitor the course of the drive via the landing
panels at all stops upwards and downwards.
Yes □
Check the floor indicator, out of operation indicator, direction indicator Yes □
Check light barrier, clamping force limiter, emergency alarm, etc. Yes □
You can now continue with the optimisation of the drive behaviour.