496759
Page
35
4. Transferring The Program
Once you have set up the program you must transfer it into Homelink’s
memory. The instructions below show you how to transfer a program from
the PSION programmer into Homelink.
1.
Connect Homelink and the PSION programmer (see page 9) and start
the Homelink program if you have not already done so.
The display shows:
PROGRAM DEFAULTS
TX RX OFF QUIT
2. Press
T.
The display shows:
TRANSMITTING
Tx 00
The PSION programmer starts transmitting the
program data. Homelink turns on all four lights on
its front panel. The programmer changes the
number at the right of the display every few
seconds to show how much data it has sent.
Homelink bleeps as it receives each block of data.
After a few seconds the programmer completes
transmission, Homelink turns off the Line Fault
and Away lights, and the PSION display shows:
PROGRAM DEFAULTS
TX RX OFF QUIT
Note: If the words TIME OUT flash on and off then Homelink has not accepted the
program. See below.
3.
Disconnect the programmer cable from Homelink.
You have now completed programming Homelink.
4.
Replace the access panel and tighten the securing screw.
Program Will Not Transfer
If the words TIME OUT flash in the PSION programmer's display then:
1.
Remove power (both mains and battery) from the Homelink.
2.
Switch off the PSION programmer.
3.
Apply power to the Homelink and switch on the PSION Programmer.
4.
Send the program to the Homelink again.
Do not try to record the program from the Homelink into the Programmer,
since it is likely to be corrupted.
Summary of Contents for HOMELINK EXTRA
Page 38: ...Page 38 496759 Notes ...
Page 39: ...496759 Page 39 Notes ...
