Page 30
496759
1.
Start the HLEXTRA program and execute the PROGRAM command.
The display shows:
ACCOUNT NO. 1
2.
Press down arrow until the display shows the words “AUX OUTPUT
TIMER”.
The display shows:
AUX OUTPUT TIMER
LATCHED
(Note that this is the default.)
Note: “Latched” means that the output will stay energised until someone operates
the Privacy switch.
3. Press
EXE
The display shows:
AUX OUTPUT TIMER
_
4.
Key in the number of seconds Homelink should energise the auxiliary
output (enter “0” for a latched output).
The display shows the time you enter,
for example:
AUX OUTPUT TIMER
20_
5. Press
EXE
The programmer converts the time to minutes
and seconds (note that it rounds to the nearest
six seconds).
AUX OUTPUT TIMER
0:18 MINS:SECS
6.
Press down arrow until the display shows the words “AUX OUTPUT
RELAY”.
The display shows:
AUX OUTPUT RELAY
NORMALLY OFF
(Note that this is the default.)
7.
Press left or right arrow to change from normally off to normally on.
The display shows:
AUX OUTPUT RELAY
NORMALLY ON
Note: If you set the auxiliary output relay to “Normally On” then the resulting current
drain will reduce the battery stand-by lifetime.
Security Code
To make sure that unauthorised people cannot change the Homelink
programming from the local telephone or from the monitoring centre, you can
set up a security code. Once set up, users must enter the code before
Homelink will accept programming changes using the local telephone.
1.
Start the HLEXTRA program and execute the PROGRAM command.
The display shows:
ACCOUNT NO. 1
Summary of Contents for HOMELINK EXTRA
Page 38: ...Page 38 496759 Notes ...
Page 39: ...496759 Page 39 Notes ...
