Scantronic HOMELINK EXTRA, Programming Manual

Page: 15 / 40

496759 Page 15
2. Press EXE.
The display shows a cursor at the beginning
of the bottom line:
ACCOUNT NO. 1
_
3. Enter the account number.
The display shows the number as you enter it:
ACCOUNT NO. 1
1234_
4. Press EXE.
The display shows the completed number
and removes the cursor:
ACCOUNT NO. 1
1234
Telephone Number
Homelink can call any of its four stored telephone numbers during an alarm
call or a security alert. For each number you can program:
•
The number itself, up to 28 digits long.
• An account number or ident code, up to eight digits long (see "Account
Number").
• Its communications format (see "Comms Format").
Note:
• Do not program Homelink with duplicate telephone numbers.
• Do not program Homelink with the telephone numbers of the emergency
services (for example “999”).
• If you are using Homelink in a warden controlled only site, then do not
publish the telephone number you have programmed into the unit. Homelink
cannot receive calls from a normal telephone.
1. Start the HLEXTRA program and execute the PROGRAM command.
The display shows:
ACCOUNT NO. 1
Note: If you want to change the telephone number for one of the other call
destinations, press the down arrow key. The display shows the destination you
have selected on the top line.
2. Press the down arrow key until the display shows the words -
“TELEPHONE NO ”.
The display shows:
TELEPHONE NO. 1
3. Press EXE.
The display shows a cursor at the beginning
of the bottom line:
TELEPHONE NO. 1
_
4. Enter the telephone number. (See the notes opposite.)
The display shows the number as you enter it:
TELEPHONE NO. 1
P01234567890_