Scantronic HOMELINK EXTRA, Programming Manual

Page: 9 / 40

496759 Page 9
2. Using the PSION Programmer
To program Homelink with the PSION programmer:
1.
Connect the programmer to Homelink using the special cable.
2. Record the program from the Homelink unit into the programmer.
3. Make any changes to the program on the programmer.
4. Transmit the changed program back into Homelink.
5. Disconnect the programmer from Homelink.
6. Always test the new program on the Homelink unit.
CAUTION: Make sure you use the method outlined in steps 1 to 6 above,
especially if you use the same programmer for other types of Homelink unit.
Otherwise some Homelink units may not work correctly.
Note: If the programmer flashes the words "Time out" repeatedly then that means
that the programmer cannot communicate with the Homelink. Carry out the
following steps:
1. Remove the programming lead from the PSION programmer.
2. Switch OFF the PSION programmer, either by press "O" or by selecting
"OFF" on the menu.
3. Switch ON the PSION programmer using ON/CLEAR.
4. Press ON/CLEAR again.
5. Insert the programming lead into the PSION programmer again.
The Programmer
Figure 3 shows the keypad of the PSION programmer.
SPACE
EXE
SHIFT DEL
Y Z
M N O P Q R
G H I J K L
A B C D E F
ON
MODE
S T U V W X
CLEAR CAP NUM
< >
( ) % /
= "
7 8 9
*
,
$
4 5 6
-
;
: 1 2 3 +
0 .
Figure 3. PSION Programmer.