Section 2: Installation
TH2 Series Operator Manual
Page 2-5
2.3 LOADING MEDIA (cont’d)
2.3.2 To route the label when using the dispenser
1.
Follow the procedures in
Section 2.3.1 Loading Roll media
, from step 1 to 4, to load the roll media onto
the media holder.
2.
Pull the two corners of the
pressure bracket
out to open
the
pressure bracket
.
3.
Peel off the first two leading labels from the liner (back-
ing paper) and then pull out the leading liner (backing
paper) from the
media holder
.
Pass the liner (backing paper) over the
dispenser plate
so as to cover it. Then pass the liner (backing paper)
under the
pressure bracket
as shown.
4.
If the paper is not taut, roll the paper on the
media
holder
so that the paper is taut.
Next, tightly close the
pressure bracket
with the liner
(backing paper) passing through it.
Pressure
bracket
Dispenser plate
Dispenser unit
Media guides
Dispenser
plate