Samsung IFA Series, Installation Manual

Page: 201 / 219

LED R&D Lab(VD)
200
Appendix 1 –
S-Box Network IP Settings
Using the file explorer, go to the folder where LSM is installed,
Run [Start]-Programs-Samsung-LED Signage Manager-Network
Configuration.
1. Connect PC and S-Box with RS232C Cable, select the connected Serial
Port, and click Open button to connect.
2. The ID of S-Box is set to 1 by default.
3. Enter S-Box's IP, Subnet Mask, Gateway, and DNS, and click Apply button
to transmit.
4. Check the result. Check the MDC Protocol setting status.
5. If the IP setting is successful, the Change Type to RJ45 button is displayed.
If the connection between LSM and S-Box works normally, click Change
Type to RJ45 to change the S-Box connection mode to RJ45.
3
1
2
4
[★ Caution!] It is recommended to set a static IP address when setting up
the S-Box network.
If the IP is changed when using DHCP, the LSM connection may be lost.
The 192.168.10.x band is used for communication inside the LED Cabinet.
Please use an IP other than the applicable band.
Do not assign an IP randomly, but get an S-Box (one) IP assigned through
your IT administrator.
■
S-Box Network IP setting using PC