Starting & Driving
The following conditions must be fulfilled to activate HHC:
• Close the driver side door and fasten the seat belt.
• Stop the vehicle on a slope with certain extent.
• SCS is fault free.
• EPB is released and fault free.
• Clutch pedal is pressed (MT), or in D or R gear (AT).
• Engine is started.
• Sufficient brake pedal application force has been applied.
If the driver releases the brake pedal on a hill, HHC will
maintain brake pressure for 1
～
2 seconds. If the vehicle
fails to start in such 1
～
2 seconds, the brake automatically
releases and the vehicle slips, the brake pedal should be
depressed immediately in such a case.
Note: HHC is available in both forward and backward
directions when pulling away on uphill slopes.
Note: When the message centre of instrument pack
shows "Hill Hold Unavailable", it indicates that the
hill hold control is invalid or is not properly enabled,
please seek an MG Authorised Repairer urgently.
Auto Hold
When auto hold stops the vehicle for reasons
such as engine cut out, releasing the seat
belt or pressing the auto hold switch, the
electronic parking brake is applied.
It
cannot be guaranteed that the vehicle will
be stabilised in all cases. For example, the
rear wheels are on a slippery road surface,
or the vehicle incline is too great (larger than
20%). Please make sure that the vehicle is
safely stabilised prior to exiting.
DO NOT take any extra risks when driving
due to the fact the vehicle is fitted with
additional convenience functions. The driver
should pay full attention and observe the
surroundings even if the vehicle is equipped
with auto hold system.
The auto hold function cannot guarantee the
stability of the vehicle when starting off or
braking on hills especially on slippery or icy
surfaces.
199
4
Summary of Contents for MG HS
Page 88: ......
Page 166: ...Seats Restraints normally for those about 7 years old or those older than 7 years old 152...
Page 269: ...Emergency Information Code Specs Function F53 F54 255 5...
Page 272: ......
