SAIC MOTOR MG HS, Manual

Page: 170 / 319

Starting & Driving
A B
C D
1 Press the button (A) on the smart key to eject the
decorative trim.
2 Take out the backup mechanical key (B) in the
arrowed direction.
3 Use a flat-bladed tool to insert into the side of the
key (C), carefully prise off the battery cover till the
buckle comes off, and then separate the upper/lower
cover carefully along the interface (D).
4 Remove the battery from the slot.
5 Put the new battery in the slot, and make sure it is in
full contact with the slot.
Note: Make sure that the polarity of battery is
correct ('+' side facing down).
Note: It is recommended to use a CR2032 battery.
6 Refit the cover and press tightly, check if the gap
around the cover is even.
7 Refit the mechanical key, and close the decorative
trim.
8 Start the engine to resynchronise the key with the
vehicle.
156