187
Unless stated otherwise, all dimensions are given in mm.
MANTO®
Shaft spindle
The shaft spindle consists of a Centre Tube, the Left and Right Spindle and 2no. Waler
Bolts D20 with a Spring Cotter Pin 4.
The shaft spindle has to be fastened with two Panel Clamps each at the element joint of
the Outer Corner.
Min.: 50 mm / max.: 200 mm
in 50 mm increments.
Right Spindle
(code:524700)
with blue marking.
500
800
1100
1400
1700
2000
50 - 200
Centre
Tube
Waler Bolt D20
(code:420000)
+ Spring Cotter Pin
4 (code:173776)
200
Left Spindle
(code:524710)
with red marking
Min.: 100 mm
Max.: 300 mm
(during installation:
270 mm min. extension)
Always install the spindles in the extended condition (270 mm minimum) in order to
obtain adequate spindle retraction for stripping.
Inside shaft dimension
Centre Tube
Product code
1.45 m - 1.75 m
0.50 m
524721
1.75 m - 2.05 m
0.80 m
524732
2.05 m - 2.35 m
1.10 m
524743
2.35 m - 2.65 m
1.40 m
524754
2.65 m - 2.95 m
1.70 m
524765
2.95 m - 3.25 m
2.00 m
524776
Summary of Contents for Huennebeck MANTO G3
Page 1: ...MANTO Large frame panel formwork User guide...
Page 9: ...9 Unless stated otherwise all dimensions are given in mm MANTO...
Page 61: ...61 Unless stated otherwise all dimensions are given in mm MANTO MANTO G3 M MANTO G3 M...
Page 219: ...219 Unless stated otherwise all dimensions are given in mm MANTO...
