Sacmi Imola CHS Series, Instruction Manual

Page: 91 / 116

062AZ005A
ADJUSTMENTS 7
7-7
7.3.3 ADJUSTING CYLINDER YV3 AND TIMING SENSOR SQ6 IN THE TURN-PLATE SPACER
- Loosen the screws of the pneumatic cylinder support 1 .
- Lay the cap 2 immediately after the tip of the turn-plate 3 .
- The piston 4 of the pneumatic cylinder YV3 should stop the cap without tolerance in the tangency point of the cap
2 with the turn-plate 3 .
- Tighten the screws of the pneumatic cylinder support 1 .
- Loosen nuts 5 and sensor SQ6 .
- Place SQ6 at 0.5/1 mm from the turn-plate 6 .
- Shift SQ6 until the reading activation light on SQ6 comes on (do not shift the turn-plate 3 from the initial position).
- Tighten nuts 5 in sensor SQ6 .