Note:
Installation direction identifier of the
air filter
Handle of Air filter
Installation location for the air filter
To install the air filter , follow these steps:
1)
Pull out the filler panel of the air filter.
2)
Insert the air filter along the slide rail. Note the direction identifier to ensure the correct direction.
Figure 3-2 Installing the Air Filter of the Supervisor Module and Service Module on the RG-N18014 Switch
The following describes how to use the air filter assembly:
Air filter assembly in working state: the tab is locked in the back limits.
After the air filter is inserted into the chassis, make sure the air filter is in working state.
Figure 3-3 Air Filter Assembly in Working State
If the rack is not long enough for the air filter, push in the inside casing of the air filter to reduce the length of the assembly
so that you can easily plug/unplug the air filter. To push in the inside casing, hold and press the tab and move it forward to
the front limits (see Figure 3-4). Conversely, you can pull out the inside casing of the air filter. (see Figure 3-5)
Summary of Contents for RG-N18010
Page 1: ...RG N18000 Series Switches Hardware Installation and Reference Guide V1 08...
Page 89: ...2 RG N18010...
Page 121: ......
