2)
Take out the SFP+ module you want to install from the packing bag.
3)
Plug the SFP+ cable to the SFP+ port through the connector. Pay attention to the proper end for connection.
During the operation, make sure that the cable’s bending radius is no less than eight times as much as its
diameter.
Installing 40-Gigabit QSFP+ Modules
To avoid damaging components due to operation errors, read this section carefully before installing
40-Gigabit QSFP+ modules.
Take the following steps to install 40-Gigabit QSFP+ modules:
1)
Turn up the handle of the module into the top bail-clasp latch. Hold both sides of the module and push the module
into place (You can feel that the module is placed in position with a click sound), as shown in figure 3-36
2)
Push the module gently into the QSFP+ module slot until you hear a click, indicating the module is correctly installed,
as shown in figure 3-37.
Figure 3-36 Installing the QSFP+ Module Equipped with a Bail- clasp Latch
Figure 3-37 Installing the QSFP+ Module Equipped with a Pull Tap
3)
Use the fiber optical patch cord to connect the 40G QSFP+ module to the fiber optical network. Select the patch cord
with the connector corresponding to the port.
4)
After the patch cord is connected, the Link/ACT Status LED is on. Otherwise, please check connection of the patch
cord.
Precaution
Pay attention to the proper end of the QSFP+ module for installation. If the QSFP+ module cannot be inserted to the
end, do not push it forcefully. Please try the other end of the module.
It is recommended that you do not remove the protective rubber plug from QSFP+ module before connecting fibers.
Summary of Contents for RG-N18010
Page 1: ...RG N18000 Series Switches Hardware Installation and Reference Guide V1 08...
Page 89: ...2 RG N18010...
Page 121: ......
