RTW 10689, Operating Manual

Page: 166 / 186

RTW DigitalMonitor 8ch 10689 166
3. Remove the three (10689) resp. two (10689-PLUS) screws at the bottom
of the DigitalMonitor 8ch (A) which hold the connector panel in place. Take
out the three screws (B) fixing the main pcb. Carefully remove connector
panel and main pcb (C) and store them at a ESD protected place.
(Fig. E 7-4)
4. Loose carefully the wide locker (right above on the display pcb) of the
other side of the connecting flat cable. Avoid damage of the locker and
the connecting flat cable because of canting. Store the cable with the
discarded main pcb. (Fig. E 7-5)
Fig. E 7-4: Unscrew and removal of connector panel and main pcb
Fig. E 7-5: Removal of the connecting flat cable from the display pcb
E 7 Service • E 7.2 Display exchange
Screw in the middle
with 10689 only