Ross 4500DR-104-07, User Manual, Page: 82 / 161

82 • Front Panel Menu System SRG-4500 User Guide (v7.0)
There is a changeover relay within the SRG-4500 selecting either the SRG-4500 generated 10MHz or the external
10MHz. This is used to allow 10MHz to be passed to other external equipment if the SRG-4500 is powered down
either purposefully or due to failure.
This menu item selects the operation mode of the 10MHz relay. The options are: External, Internal, and Automatic.
Programmable Balanced Outputs
This menu row allows the user to select which balanced signal types appear on the rear panel when using the
Breakout option. Any of the following signal types may be selected on any programmable balanced pin output pair
(i.e. all 8 programmable outputs may be the same signal, or may be all different, etc.).
Note that some pin pairs are fixed (and are not configurable) as follows:
• Pin 19+, Pin 20- are set to AES2
• Pin 21+, Pin 22- are set to AES 1
• Pin 23+, Pin 24- are set to DARS
• Pin 25+, Pin 26- are set to Left Analog Audio
• Pin 27+, Pin 28- are set to Right Analog Audio
Network Menu
Figure 7.24 provides an example of the Network menu.
Figure 7.24 Network Menu Example
When the NTP option is not enabled, the line appears as:
-NTP........Option not enabled
The Network menu, and the associated sub-menus, allows the user to configure and control the behavior of the
Ethernet system within the SRG-4500.
 Before proceeding, the user must contact their Network Administrator, and obtain suitable IP addresses, etc., that
will need to be programmed within this menu.
IP Address
This menu line allows the user to enter the IP address of the SRG-4500. The options in the sub-fields “000” are: 000
through 255 where 000" is the default “no action” setting.
To change the settings
1. Press the rotary control to advance through each sub-field.
2. Turn the rotary control to change the value of the currently selected sub-field.
SubNet Mask
This menu line allows the user to enter the SubNet Mask address of the SRG-4500.
The options in the sub-fields are: 000 through 255. The default is “000” (no action).
000.000.000.000
Gateway 000.000.000.000 =
- MAC Address 000.000.000.000 =
- NTP Menu Enter ->
- DashBoard Menu Enter ->
- Backup Device Menu Enter ->
Subnet Mask 000.000.000.000 =
IP Address =