Ross 4500DR-104-07, User Manual, Page: 126 / 161

126 • Installing the Breakout PCB SRG-4500 User Guide (v7.0)
To wire a 3-pin connector
1. Insert a wire to the designated polarity slot on the connector of the rear panel. ( Figure 13.5 )
Figure 13.5 Connector Wiring for the Breakout PCB 3-pin Connectors
2. Use a tweaker screwdriver to tighten the corresponding capture screw.
3. Repeat steps 1 and 2 for each wire on each connector.
4. Once the cables are wired to the connectors, install the connectors on the terminal blocks of the Breakout PCB.
Connector
End View
Connector
Top Views
Connector
Side View
Polarity
Indications
(without cable)
Audio Cable
Connector
Tie Wrap
RossGear