Ross 4500DR-104-07, User Manual, Page: 124 / 161

124 • Installing the Breakout PCB SRG-4500 User Guide (v7.0)
To install the Breakout PCB on the rack tray
1. Position the Breakout PCB atop the screw posts on the tray. Refer to Figure 13.1 .
Figure 13.1 Installing the Breakout PCB on the Rack Tray
2. Affix the Breakout PCB using the provided four M310mm screws with lock washers (88-0095).
Installing the Breakout PCB into the Rack Frame
The Tray installs between the rear support brackets so that the 30-pin connector is aligned with the BALANCED
30-pin connector on the SRG-4500 rear panel. This section outlines how to affix the tray to the rear support
brackets.
To install the Breakout PCB in the rack frame
1. Position the Breakout PCB and Tray behind the SRG-4500 in the rack frame (
Figure 13.2
) while ensuring to:
• position the Breakout PCB so that its white 30-pin connector is aligned with the SRG-4500 rear panel 30pin
connectors;
• leave enough space between the SRG-4500 rear panel and the Breakout PCB to properly cable the
connectors.
Figure 13.2 Installing the Breakout PCB and Tray to the Rear Brackets
2. Use the 4 provided M3 5mm screws to affix the Breakout PCB and Tray to the Rear Brackets of the SRG-4500.
Refer to Figure 13.2 .
TRA
Y
PCB
GbE / PTP
100-BaseT
1Hz
10MHz IN
10MHz
WK/TTL1
WK/TTL
2
COMPOSITE
6Hz/TTL3
DARS
AES 1
AES 2
REF LOOP
BLACK 1
SRG-4500
REAR BRACKET
PCB
TRI/BLACK 2
TRI/BLACK 3
TRI/BLACK 4
SDI 2 BLACK
SDI 4 BLACK
SDI 1 BLACK
SDI 3 BLACK
SDI 2
SDI 4
TRA
Y
REAR BRACKET
GPS
BALANCED AUDIO/AES/L
TC
SDI 1
SDI 3