Instrument Function
R&S
®
SMBV100A
391
Operating Manual 1407.6062.32 ─ 08
Example:
The following graph shows the setting range for the frequency offset.
Fig. 5-23: 3GPP FDD signal (chip rate 3.84 Mcps, root-cosine filter 0.22).
The complex useful bandwidth of a signal which has been filtered using a root-cosine
filter with roll off alpha is calculated as follows:
f
use
= (1+ alpha) * f
symbol
f
symbol
= the symbol rate or chip rate of the signal.
In the example the complex useful bandwidth is calculated as follows:
f
use
= (1+ 0.22) * 3.84 MHz = 4.6848 MHz.
So as to comply with the condition requiring a maximum I/Q bandwidth of 40 MHz, the
valid range of values for the frequency offset is then:
-60 MHz + 4.6848 MHz /2 <= f
offset
<= 60 MHz - 4.6848 MHz /2 or
-57.6576 MHz <= f
offset
<= 57.6576 MHz
In the case of ARB signals, the output clock rate can be used for estimating the maximum
I/Q bandwidth of the waveform.
SCPI command:
Phase Offset
Enters the phase offset for the external baseband signal.
The offset affects the signal on the output of the "Baseband In/Out" block.
SCPI command:
n.a.
External Baseband Signal - Baseband Input
Summary of Contents for SMBV100A
Page 31: ......
