Rohde & Schwarz R&S FPH, User Manual

Page: 293 / 484

Remote Commands
R&S ® Spectrum Rider FPH
288 User Manual 1321.1011.02 ─ 06.00
Return values:
<ErrorCode> integer > 0 (in decimal format)
An error occurred.
0
No errors occurred.
Usage: Query only
*WAI
Wait to continue
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC
).
Usage: Event
13.6.2 Remote Commands of the Spectrum Analyzer
This section provides a detailed description of all remote control commands required to
configure and perform measurements with the spectrum analyzer. These commands
are available in spectrum analyzer mode only.
●
Configuring the Horizontal Axis .............................................................................288
● Configuring the Vertical Axis ................................................................................. 292
● Setting the Bandwidths ......................................................................................... 298
● Performing and Triggering Measurements ............................................................300
● Working with Traces ..............................................................................................304
● Using Markers .......................................................................................................309
● Using Limit Lines ...................................................................................................323
● Configuring and Using Measurement Functions ...................................................329
13.6.2.1 Configuring the Horizontal Axis
The following commands configure the horizontal (frequency) axis of the active display.
Commands independent of the operating mode
Note that some of the commands for configuring the horizontal axis are also valid for
other operating modes. If a command is available in another mode, it is indicated by
the list in the respective section.
List of commands
●
[SENSe:]FREQuency:CENTer
on page 289
●
[SENSe:]FREQuency:CENTer:STEP
on page 289
●
[SENSe:]FREQuency:CENTer:STEP:LINK
on page 289
●
[SENSe:]FREQuency:INPut:MODE<1..3>
on page 290
Remote Control - Commands