Rohde & Schwarz R&S FPH, User Manual

Page: 390 / 484

Remote Commands
R&S ® Spectrum Rider FPH
385 User Manual 1321.1011.02 ─ 06.00
13.6.9 Saving Events
The following commands configure the circumstances under which the R&S Spectrum
Rider saves events.
These commands are independent from the operating mode.
Using the commands requires a GPS receiver and a storage device (SD card or mem-
ory stick).
List of commands
●
SYSTem:SOEVent:DISTance:INTerval
on page 385
●
SYSTem:SOEVent:LIMits:MODE
on page 385
●
SYSTem:SOEVent:RECording:STORage
on page 386
●
SYSTem:SOEVent:SOURce
on page 386
●
SYSTem:SOEVent:TIME:INTerval
on page 386
●
SYSTem:SOEVent[:STATe]
on page 387
SYSTem:SOEVent:DISTance:INTerval
<Seconds>
This command defines a distance that you must cover before the R&S Spectrum Rider
saves another coordinate.
Parameters:
<Seconds> Distance between one coordinate and the next.
*RST:
1 m
Example:
SYST:SOEV ON
Turns on saving coordinates on an event.
SYST:SOEV:REC:STOR USB
Selects a USB device as the storage device.
SYST:SOEV:SOUR DIST
SYST:SOEV:DIST:INT 5
Saves the coordinates every 5 m.
SYSTem:SOEVent:LIMits:MODE <arg0>
This command selects the limit check condition that must occur in order to save a coor-
dinate.
Parameters:
<arg0> STARtonfail | STOPonfail | FAILonly
STARtonfail
Starts to save all sweeps from the moment a limit check fails.
STOPonfail
Saves all sweeps until a limit check fails.
FAILonly
Saves only sweeps that contain a limit check violation.
*RST:
STAR
Remote Control - Commands