Rohde & Schwarz R&S FPH, User Manual

Page: 392 / 484

Remote Commands
R&S ® Spectrum Rider FPH
387 User Manual 1321.1011.02 ─ 06.00
Example:
SYST:SOEV ON
Turns on saving coordinates on an event.
SYST:SOEV:REC:STOR USB
Selects a USB device as the storage device.
SYST:SOEV:SOUR TIM
SYST:SOEV:TIME:INT 5
Saves the coordinates every 5 seconds.
SYSTem:SOEVent[:STATe] <State>
This command turns saving of your current coordinates in case of certain events on
and off.
Parameters:
<State> ON | OFF
*RST:
OFF
Example: See
SYSTem:SOEVent:DISTance:INTerval
on page 385
13.6.10 Configuring the Instrument
The following commands configure general instrument settings.
These commands are independent from the operating mode.
Contents
●
Chapter 13.6.10.1, "Mode Selection" , on page 387
●
Chapter 13.6.10.2, "Controlling the GPS Receiver" , on page 388
●
Chapter 13.6.10.3, "Display Configuration" , on page 390
●
Chapter 13.6.10.4, "Audio Settings" , on page 392
●
Chapter 13.6.10.5, "Setting up a Network Connection" , on page 393
●
Chapter 13.6.10.6, "System Settings" , on page 394
13.6.10.1 Mode Selection
This chapter describes all commands that select the operating mode of the R&S Spec-
trum Rider.
List of commands
●
INSTrument[:SELect]
on page 387
●
INSTrument:NSELect
on page 388
INSTrument[:SELect] <OperatingMode>
This command selects the operating mode.
Remote Control - Commands