Preparing for Use
R&S
®
QAR
23
User Manual 1178.7200.02 ─ 09
Note
: Insert a washer between screw and mounting table as shown in
Figure 4-7: DUT mounting table and transmitter module installation
Installing the DUT mounting table on the floor
Altenatively, you can install the DUT mounting table directly on the floor.
1. Drill holes into the floor.
The locations and distances of the drill holes are indicated in
.
2. Screw the table to the floor with four anchor bolts, size 6
mm, for example a
Fischer FAZ II 6.
The anchor bolts are not included in the delivery.
Attaching the transmitter module to the mounting table
You can install the transmitter module required for transmission loss measurements on
top of the DUT mounting table. The DUT mounting table already comes with the nec-
essary mounting holes.
1. Place the transmitter module on top of the mounting table.
2. Screw the transmitter module to the mounting table using the torx wrench.
Installing the R&S
QAR
